CanMaking.Info Forum / Materials / Aluminium / bleed through

Post Reply 
 
Thread Rating:
  • 22 Vote(s) - 3.05 Average
  • 1
  • 2
  • 3
  • 4
  • 5
bleed through
18-09-2014, 04:34 PM
Post: #1
alessio Offline
Junior Member
**
 		Posts: 10
Joined: Sep 2014
Reputation: 3
Country: Italy
bleed through
this defect in the construction of the can two pieces now is not very frequent. my question is what have we improved:  tool materials? improved oils? improved alloys? in short what technologies are changed to control this defect ?
alessio
Alessio Andreoli
Production Manager
REXAM BEVERAGE CAN 
Nogara (vr)
Italy
http://www.rexam.com
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
bleed through - alessio - 18-09-2014 04:34 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | CanMaking.Info | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication