Post Reply 
 
Thread Rating:
  • 25 Vote(s) - 2.68 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Eurocan 110G Linear Seamer
23-11-2014, 04:52 PM (This post was last modified: 23-11-2014 04:57 PM by John Jenner.)
Post: #5
Photo RE: Eurocan 110G Linear Seamer
The final part of the assembly process is fitting the safety guarding. This comprises four stainless steel panels around the bottom of the seamer, which are attached to the table frame with mounting studs and security socket screws, left and right upper safety frames with polycarbonate panels, and a rear folding door assembly. A pair of polycarbonate canopies also ship with the seamer that sit on mounting studs over the top of the end feed assembly and facilitate access to the stack rods for replenishing ends.

Also now fitted is the seaming head safety guard covering the drive pulleys and belts, the Deublin rotary union on top of the end feed turret shaft for plumbing the Nitrogen gas to the centering rings, and the extruded clip on wear strips on the can guide rails.

[Image: 2014-11-14155314_zps600e28d2.jpg]

[Image: 2014-11-14155343_zps289954de.jpg]

[Image: 2014-11-14155421_zpsd25d7048.jpg]

[Image: 2014-11-14155438_zpsa1b54c64.jpg]

[Image: 2014-11-14155441_zps880fdcc2.jpg]

[Image: 2014-11-14155504_zps0df28162.jpg]

[Image: 2014-11-16153952_zpsf8512016.jpg]
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Eurocan 110G Linear Seamer - John Jenner - 22-09-2014, 11:01 PM
RE: Eurocan 110G Linear Seamer - John Jenner - 23-11-2014 04:52 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)